Can I Interrupt Clean Cycle On Bravos Washer

12

WASHER MAINTENANCE

CLEANING YOUR WASHER

Keep your washer every bit make clean and fresh as your wearing apparel.

To keep washer interior odor-gratis, follow this

recommended monthly cleaning process:
1. Make sure the washer is empty.
2. Using recommended AFFRESH

®

washer cleaner,

add together one tablet to washer drum.

OR
If using liquid chlorine bleach, add 1 cup (250 mL) to

liquid chlorine bleach dispenser.

Important: Practice not add detergent to CLEAN

WASHER with AFFRESH

™

cycle. Do not employ more than

recommended amount of bleach to avert damaging

product over fourth dimension.
3. Close washer lid.
4. Press Power/CANCEL.
5. Select CLEAN WASHER with AFFRESH

™

cycle.

vi. Press START/Pause. Water will cascade into washer

for a moment and intermission, hat will lock, and so bike

will go along.

NOTE: For best results, do not interrupt bicycle. If bike

must be interrupted, press START/Interruption twice and run a

RINSE AND SPIN cycle to ensure cleaner or bleach have

been rinsed from washer.

To clean outside:
1. Utilize a soft, damp material or sponge to wipe upwardly any spills.
2. Use all-purpose surface cleaner, if needed.
IMPORTANT: To avoid damaging the washer'due south stop,

do not utilize abrasive products.

Replace inlet hoses after 5 years of use to reduce the hazard

of hose failure. Periodically audit and replace inlet hoses

if bulges, kinks, cuts, wear, or leaks are constitute.

When replacing your inlet hoses, marker the date of

replacement on the label with a permanent marker.

Water INLET HOSES

10.

Printing START/Break to begin

launder cycle

Printing the START/PAUSE push to get-go the launder bike. Filling

is delayed for several minutes while load balance is sensed.

When the bike has finished, the finish of cycle betoken will sound

(if set). Promptly remove garments when cycle is done to avert

olfactory property, reduce wrinkling, and rusting of metal hooks, zippers,

and snaps.
If lid is left open for more than than 10 minutes the h2o volition

pump out.

Delay in h2o make full

Filling is delayed for 2 to iii minutes to cheque for load unbalance.

You will hear the hum of the spin prior to filling. This is normal

performance.

nine.

Select cycle options

Select any other cycle options you may wish to add, if not

previously fix. Some cycles will automatically add together certain

options such every bit Clean Boost. These may be turned off,

if desired.
Annotation: Not all options are available with all cycles.

Source: https://www.modes-d-emploi.com/manuals/114669/maytag-bravos-w10373815a-sp-bravos-w10373814a.html?page=12

Posted by: weishaarmillan.blogspot.com

Share this post